It is important to check the water and the refrigerant levels at least once a month. If you find that there is a problem with the coolant or the radiator, either due to loss or damage caused by corrosion or cracks, then it is time for you to find spare parts for your vehicle. If you drive a truck, you can go directly to reputable dealers of truck accessories and parts for direct replacement products. However, if you are on a tight budget, you can consult a mobile auto repair San Francisco so they can give you some suggestions and recommendations.

While once a month may be frequent enough for most vehicles, there are cases where you need to check the fluid levels more often. You can check the fluid levels weekly or every two weeks if:

The gauge of temperature of your vehicle on the instrument panel shows higher numbers, even when the vehicle is stationary or parked.
It is summer and you believe that your vehicle is in danger of overheating constantly.
Also, note that you need to clean the radiator every six months or as often as your owner’s manual recommends. This helps in ensuring the effectiveness of the cooling water mixture in the radiator and in order to get rid of any residue or dirt that may have made its way into the cooling system of your vehicle.
Notice how most of the radiator coolants or fluids are usually yellow-green? However, this is only one of many different types of mixtures of water with commercially available refrigerant. The colors may also vary once the antifreeze or coolant is finally mixed with water or has been in the tank for a period of time.

To check your vehicle coolant mixture level, just follow these simple steps. However, for professional help, you can hire the services of a mobile car repair San Francisco.

Step 1: Open the hood of your car.

Step 2: Find the overflow tank coolant. It should be located near the radiator of your car.

Step 3: Check the markings located on the tank to see if you have an adequate amount of liquid in the tank or if you need to add more. If you find that you have enough fluid in the overflow tank, close the hood and you have finished with your inspection. If not, proceed to the next step.

Step 4: Release the tank pressure cap release.

Step 5: Add the proper amount of mix water and coolant as indicated in the owner’s manual of your vehicle. Be sure to clean up any spilled drop of mixture.

Step 6: Replace the cap and close the hood of your cap.